The Principle of Hans Color Device

I noticed that Hans Coler Device is permanent magnet wrap around with wire coil similarly to Jack Hilden Brand electromagnet motor . It looks like magnetic flux switch turning the magnetic flux from permanent magnet on and off. Daniel MacFarland Cook invention also uses about coil around magnetic core and permanent magnet, but it has inner and outer coils them.

The Race to The Zero Point Energy

The video of The Race to The Zero Point Energy.

Curved Space Time

In flat space time, we can only get a triangle with a total angle of 180 degree. We can never have 3 90 degree angle corners for triangle. In curved space time, however, this is very different. Imagine you make a 90 degree angle corner at the north pole, and make two north to south lines from the corner down to equator. At the equator, one line make a 90 degree left turn and the other make another 90 degree right turn. and make a line length of a quarter of equator circumference. Here you have a triangle of three 90 degree angle corners in curved space time.

How do we get more energy out from curved space time then?

Cold Electricity

1893: Nikola Tesla demonstrated the illumination of vacuum bulbs wirelessly (without any wires connected to the bulbs) at the World Columbian Exposition in Chicago.
EV Gray demonstrated lighting up a bulb inside the water without being electrocuted. Dr. Lindemann who studied EV Gray patents can also reproduce tesla wireless bulb with one hand touching the base of the bulb and another friend touching the other terminal of the bulb, when the replicated Tesla wireless transmitter running behind.


Richard box demonstrated fluorescent bulb lighting up under high tension power grid in UK.




German ministers holding a fluorescent bulb near Prof Konstantin Meyl's scalar wave transmitter system.

John Bedini lighted up a NE2 bulb near the plastics of lead acid battery, not even touching the plastics, with his radiant charger running. The other end of the NE2 is connected to a metal that is grounded.Eric is running one wire solid state high voltage (1-2KV) fluorescent lamp.


In all these demonstration, no closed loop circuit is involved; high potential is involved (like electrostatic charge) and the person are not electrocuted. Could this "cold electricity" power devices without heatsink?

Misleading Power Measurement in Meyl's Experiment

Professor Konstatin Meyl has replicated Tesla's wireless system in miniature form and is selling his experimental kit. He suggested a simple DC measurement on the transmitter and receiver side by placing the jumper to the DC load. The current measurement is abandoned and assume a higher voltage at the same resistor will entail also a higher current by Ohm's law. If the DC voltage at the receiver is higher than the voltage at the transmitter, a so-called Overunity effect is present and the COP is > 1.
This is really misleading because the DC load at the transmitter is in parallel to the excitation coil at the primary side. In actual fact, when the so called "overunity" effect happens, the current going into the excitation coil is very high, while it DC load voltage is very low. The best way to measure is to lift the jumper at the transmitter; hence only powering the input coil; then, switch the jumper to ac load at the receiver and measure the input rms voltage, input rms current, output rms voltage and output rms current. So far, I have not seen any overunity gain.